Roland FC-300 - Appendices; Restoring Factory Settings (Factory Reset)

55
Appendices
You can restore all of the FC-300’s settings to their original factory settings.
This is referred to as “Factory Reset.”
Use the following procedure when carrying out Factory Reset.
1
Switch off the power.
2
Hold down VALUE [ ] [ ] and switch on the power.
The message “Factory Reset Are you sure?” appears in the display.
3
Press [WRITE].
Factory Reset is executed.
When the Factory Reset is finished, the message “Completed!” appears in the
display.
4
Switch off the power.
Restoring the Factory Settings (Factory Reset)
Do not turn off the power to
the FC-300 while Factory Reset
is in progress.
If you want to cancel the
factory reset operation, turn off
the power.
FC-300_e1.book 55 ページ ２００７年４月２４日 火曜日 午前１０時１０分