Roland FC-300 - Copying and Moving MIDI Messages

38
Patch Mode
Copying and Moving MIDI Messages Within a Stream
You can copy MIDI messages saved within a MIDI stream.
Use this function when you want to program a number of similar messages in a
stream.
Messages in MIDI streams are output in the same order they are programmed.
To change the sequence of the messages in a stream, use the Move function.
1
Press PARAMETER [ ] [ ] to move the cursor to message number.
2
Press VALUE [ ] [ ] to select you want to copy (or move) message
number.
3
Press PARAMETER [ ] [ ] to select the “MOVE” or “COPY.”
4
Press [WRITE].
5
Press VALUE [ ] [ ] to select the copy destination (or move destination)
message number.
The copy (or move) message is inserted to the in front of the selected message
number.
6
Press [WRITE].
7
“Sure?” appears in the display; press [WRITE] once more.
8
After making the changes, follow the instructions in “Storing (Saving)
Patches” (p. 44) to save the MIDI messages to a patch.
FC-300_e1.book 38 ページ ２００７年４月２４日 火曜日 午前１０時１０分