Roland GI-10 - Restoring Default Settings (Initialization); Initialization Procedure

Restoring The Deraut sei ng> UORORERION,
Carry out the steps below to restore all the settings
the unit had when it was shipped from the factory
(initialize it).
< Procedure >
1. Turn the power OFF.
2. While holding down both the — and + PARA-
METER buttons, switch the power back ON.
You should see the confirmation message shown
below, which will be blinking.
3. Press the VALUE + button.
This starts the initialization process. (The message
below will be shown while the unit is being initial-
ized.)
i} ll
23