Chapter 6. Connecting External Devices
33
ENGLISH
ENGLISH
ENGLISH ENGLISH ENGLISH ENGLISH
Chapter 6. Connecting External Devices
Connecting to Audio
Equipment
You can connect audio devices to play the sound of the
HP107e through the speakers of your audio system, or to
record your performance on a tape recorder or other record-
ing device.
When connecting, please use an audio cable with a standard
phone plug (sold separately).
Connection examples
* To prevent malfunction and/or damage to speakers or other
devices, always turn down the volume, and turn off the power
on all devices before making any connections.
Playing the sound of the HP107e through
the speakers of an audio system/Recording
the performance of the HP107e on a
recording device
❍ Use the following procedure when turning on the power.
1.
Turn on the power of the HP107e.
2.
Turn on the power of the connected device.
3.
Adjust the volume of each device.
* You can adjust the volume of a connected sound module with
the HP107e.
When Recording HP107e Performances on a Recording
Device
4.
Start recording with the connected device.
5.
Perform on the HP107e.
6.
When the performance ends, stop recording on the
connected equipment.
Playing the sound of an audio device
through the speakers of the HP107e
❍ Use the following procedure when turning on the power.
1.
Turn on the power of the connected device.
2.
Turn on the power of the HP107e.
3.
Adjust the volume of each device.
* You cannot use the HP107e to adjust the volume of the con-
nected sound generating device.
Turning off the power
1.
Set the volume of the HP107e and of the connected
devices to the minimum position.
2.
Turn off the power to the HP107e.
3.
Turn off the connected equipment.
Connecting to the USB
Connector
You can use a USB connector to connect the HP107e to
your computer. For more details, refer to the separate
“USB Installation Guide.”
* Connecting your computer to the HP107e for the first time
requires installation of the “USB Driver” (on the included
CD-ROM) to the computer. For more details, refer to the sepa-
rate “USB Installation Guide.”
* Only MIDI data can be transmitted using USB.
* To prevent malfunction and/or damage to speakers or other
devices, always turn down the volume, and turn off the power
on all devices before making any connections.
* USB cables are not included. Consult your Roland dealer if
you need to purchase.
* Use a USB cable no longer than 3 meters.
* Turn on the power to the HP107e before starting up MIDI
applications on the computer. Do not turn the HP107e on or
off while any MIDI application is running.
* Do not connect or disconnect the USB cable while the
HP107e’s power is on.
* If not using USB, disconnect the USB cable from the HP107e.
* If during the transmission/reception of data, the computer
switches to energy-saving mode or suspended mode, or if
power is switched on or off, the computer may freeze, or the
HP107e’s operation may become unstable.
Input R/L (Line In,
Aux In)
HP107e
Output R/L (Line Out,
Aux Out)
HP107e
HP107_e.book Page 33 Tuesday, October 19, 2004 10:41 PM
To Next Page
Loading...
