Roland JV-1000 - Page 51

3.
How to
record a song
2. Save
the performance into
internal
memory.
Press
WRITE, use
-^/>-
so
"Write" begins to
flash,
and
then
press
ENTER.
Specify the saving destination
memory and
number
using the
patch group/
PERFORM
buttons.
Press
ENTER to execute the
Save
command.
If memory
protect is on,
the
message
will
appear, and the
protect
on/off switch
display
will
then appear.
Press
DEC
-+
ENTER
to
turn protect
off, and
then press
ENTER.
The modified
performance has now been stored
in
internal user
memory (UI16).
4. To
retain the previous
display, press
ENTER.
*
If during
the procedure you wish to
quit without
saving,
press EXIT.
Each time you
press
the button
vou will return
to
the
previous display.
*
To save
sound
data
on the
disk, use the
Bulk
Dump command
(SYNTHESIZER
MANUAL/p.109).
*
It
is also possible to
record sound
source settings at
the beginning
of song
data
(p.
66).
*
To
restore the
jV-1000's internal
memory to the
factory default
settings,
first turn its
power off.
Then
while
holding
down
the
PERFORM
16 button,
turn
power back ON
again.
You
can
then
follow the messages
that appear
in the display
for the
synthesizer
section,
and press
ENTER then
WRITE.
45