3.
How
to
record
a
song
Adjust the
volume
balance
Press the synthesizer
section
LEVEL button.
Thedisplay
will indicate the
volume setting
value for each part
as a
number
ā
1 27
(higher
numbers indicate a
greater volume).
Move the sliders
for each part
to
adjust
the volume
balance.
The volume will increase
as
the sliders
are
raised.
Adjust the pan
'
Press
the synthesizer
section
PAN button.
The display will
indicate the pan
setting value
for
each
part
between L64ā
ā
63 R.
Move the sliders for
each part to adjust the
pan. The stereo
position
of the sound will
.
move
to the right
as a
slider is raised.
4. When
you finish, press STOP.
Press RESET
->
PLAY/SAVE
to
check the mixing
data
you just
recorded.
*
If while recording
you select patches using the procedure of
"Select patch
(p.
6),"
program
change messages will
be
recorded in the recording track.
This allows you to
make
patches change
while
the song is being played back.
*
If you were not
able to
make all the
desired changes
in volume and pan, or patch
selections, you can record again
on another track.
The
Merge function (SEQUENCER
MANUAL/p.84) can
be used
to
combine
these
tracks into one
track.
A7
To Next Page
Loading...
