Roland Prelude - Viewing Prelude System Information

47
System Settings
Settings cannot be stored for the parameters marked by “*” in
the table. When the power is turned on, these parameter will
always return to the same value (the default value).
System settings that are not stored
In addition to the parameters marked by “*” in the above
table, the following settings cannot be stored.
• BALANCE button setting (p. 23)
• Recording setting (p. 28)
Rec Mode/Count In/Punch In/Out setting/Input Quantize
•D Beam controller on/off (p. 34)
• External input Center Cancel (p. 18)
•MINUS ONE/CENTER CANCEL button on/off (p. 30, p. 32)
Here’s how to view information about the Prelude such as its
software version.
1. Press [MENU].
2. Use [ ] [ ] to select “Version” then press [ENTER].
3. Use [ ] [ ] to select a page.
You can view information about the imported Special
Tones as well as the version of software used by the
Prelude.
4. Press [EXIT] to return to the Main screen.
SYSTEM LOCK
Parameter Value Explanation
Style OFF, ON
Refer to “Preserving Certain Settings
Even When You Switch
Performances (Lock System)” (p. 17).
Tone OFF, ON
Style Tem-
po
OFF, ON
Transpose OFF, ON
Viewing Information about Prelude
(System Version Info Screens)
Prelude_e.book Page 47 Wednesday, January 14, 2009 2:18 PM