Roland Prelude - Distortion → Chorus; Distortion → Flanger; Distortion → Delay; Enhancer → Chorus

79
The parameters are essentially the same as in “66: OVERDRIVE →
CHORUS,” with the exception of the following two.
Overdrive Drive → Distortion Drive, Overdrive Pan → Distortion Pan
fig.MFX-69
The parameters are essentially the same as in “67: OVERDRIVE →
FLANGER,” with the exception of the following two.
Overdrive Drive → Distortion Drive, Overdrive Pan → Distortion Pan
fig.MFX-70
The parameters are essentially the same as in “68: OVERDRIVE →
DELAY,” with the exception of the following two.
Overdrive Drive → Distortion Drive, Overdrive Pan → Distortion Pan
fig.MFX-71
fig.MFX-72
fig.MFX-73
69: DISTORTION → CHORUS
70: DISTORTION → FLANGER
71: DISTORTION → DELAY
72: ENHANCER → CHORUS
Parameter Value Description
Enhancer Sens 0–127 Sensitivity of the enhancer
Enhancer Mix 0–127
Level of the overtones generated
by the enhancer
Chorus Pre Delay 0.0–100.0 ms
Adjusts the delay time from the di-
rect sound until the chorus sound is
heard.
L in
R in
Chorus
Distortion
L out
R out
Balance W
Balance W
Balance D
Balance D
L in
R in
Flanger
Distortion
L out
R out
Balance W
Balance W
Balance D
Balance D
Feedback
L in
R in
Delay
Distortion
L out
R out
Balance W
Balance W
Balance D
Balance D
Feedback
Chorus
L in
R in
L out
R out
Mix
Mix
Enhancer
Enhancer
Balance W
Balance W
Balance D
Balance D
Chorus Rate
0.05–10.00 Hz,
note
Frequency of modulation
Chorus Depth 0–127 Depth of modulation
Chorus Balance
D100:0W–
D0:100W
Adjusts the volume balance between
the sound that is sent through the cho-
rus (W) and the sound that is not sent
through the chorus (D).
Level 0–127 Output Level
73: ENHANCER → FLANGER
Parameter Value Description
Enhancer Sens 0–127 Sensitivity of the enhancer
Enhancer Mix 0–127
Level of the overtones generated
by the enhancer
Flanger Pre Delay 0.0–100.0 ms
Adjusts the delay time from when
the direct sound begins until the
flanger sound is heard.
Flanger Rate
0.05–10.00 Hz,
note
Frequency of modulation
Flanger Depth 0–127 Depth of modulation
Flanger Feedback -98– +98%
Adjusts the proportion of the
flanger sound that is fed back into
the effect. Negative (-) settings will
invert the phase.
Flanger Balance
D100:0W–
D0:100W
Adjusts the volume balance between
the sound that is sent through the
flanger (W) and the sound that is not
sent through the flanger (D).
Level 0–127 Output Level
Parameter Value Description
Feedback
Flanger
L in
R in
L out
R out
Mix
Mix
Enhancer
Enhancer
Balance W
Balance W
Balance D
Balance D
Prelude_e.book Page 79 Wednesday, January 14, 2009 2:18 PM