Roland RD-170 - Page 15

Owner’s Manual
15
● Changing the split point
When you activate the Split mode, the key-
board is split at the “Gb3”, i.e. the Gb key more
or less in the middle. You can, however, select a
different split point and save that setting to a
Setup memory:
The split point can be set anywhere between
the B1 and the B6. There are two ways of
changing the split point:
• Press and hold [SPLIT] while setting the desired
split point with the [DEC÷NO]/[INC÷YES] buttons.
The display briefly shows the name of the note
you selected.
—OR—
• Press and hold [SPLIT] while pressing the desired
key on the keyboard.
Note: This setting can be saved to a Setup memory (see
p. 28).
Gb3
(F#3)
Left hand:
LOWER
Right hand:
UPPER
LOWER UPPERSPLIT
KEYBOARD MODE
DEC
NO
INC
YES
LOWER UPPERSPLIT
KEYBOARD MODE
RD-170 OM_GB Page 15 Monday, March 17, 2003 10:23 AM