Roland RD-300GX - Equalizer Adjustments

36
Performance
The RD-300GX is equipped with a two-band equalizer.
You can use the EQUALIZER [LOW] knob, and [HIGH] knob to adjust the level of each
frequency range.
Equalization is applied to the overall sound output from the OUTPUT jacks.
fig.Q1-28eq
1.
Turn the EQUALIZER knobs to adjust the levels in each range.
Turning a knob towards the minus (-) sign cuts the level of that frequency range; turn the knob
towards the plus (+) sign to boost the level of that range.
Depending on the knob settings, you may hear distortion. If so, use the VOLUME
slider to lower the volume.
You can use the EQUALIZER [LOW] and [HIGH] knobs to change the frequency at which
the adjustment will occur.
1.
While holding down the [EXIT/SHIFT] button, turn the EQUALIZER knobs.
You can adjust the frequency.
fig.disp
2.
After determining the value, press the [EXIT/SHIFT] button to return to the previous
screen.
Adjusting the Levels of Each Frequency Range
(EQUALIZER Knobs)
Changing the Frequency of the Low and High Ranges
NOTE
NOTE
RD-300GX_e.book 36 ページ ２００８年２月１４日 木曜日 午後１時２６分