Roland RD-300GX - Storing Settings to Setups ([WRITE] Button)

51
Using the Convenient Functions in Performances
If you want to use the changed content as a new Setup, use the following procedure to
save the settings to a Setup.
You can also change the name of a Setup.
You can store 32 Setups on the RD-300GX.
fig.Q2-19p
1.
Press the [WRITE] button, getting the indicator to light.
The following screen appears.
2.
While holding down the [EXIT/SHIFT] button, use the [DEC] [INC] buttons to move the
cursor ( ) to the positions where the characters are to be input.
3.
Use the [DEC] [INC] buttons to enter the characters.
The following characters are available.
space, ! " # $ % & ' ( ) * + , - . / 0–9 : ; < = > ? @ A–Z [ \ ] ^ _ ` a–z { | } ~
4.
Repeat steps 2–3 to input the name.
5.
Press the [ENTER] button to move the cursor to the destination Setup number.
6.
Select the save-destination Setup number, by using the [DEC] [INC] buttons.
Storing Settings to Setups ([WRITE] Button)
RD-300GX_e.book 51 ページ ２００８年２月１４日 木曜日 午後１時２６分