Roland RD-500 - ME the Layer Mode

(eee
nee
em
I
AR
TE
ST
TT
NOD
@ The Layer Mode
The
RD-500
allows
you
to
play
two
Tones
at
the
same
time.
This
can
be
achieved
using
the
Layer
Mode.
Played simultaneosly
INT LOWER part INT UPPER part
1. Select the Layer mode.
Press the LAYER button (the indicator will light).
The indicators on both the LOWER and UPPER buttons will light.
GRAND 1 GRANO 2 £GRAND. MKS-20
SPUT
DETUNE PITCH ZONE KEY TOUCH | INDICATOR: ,ocas BULK.
cHoRUS MON RHODES. EPIANO HAMS oncan
DEPTH SPOCE 0. OSENSITMITY ENO DOWN BEND UP
REVERB UPPER SYNTH. STRINGS BASS " PERCUSSION
INTERNAL SOUNDS
2. Select a Tone for the INT UPPER Part.
a. Press a Tone Selection button to choose a Tone Group.
b. Press the VARIATION button (the indicator will light).
c. While the UPPER button is flashing, select a Tone number with the INC/DEC buttons or the
VALUE slider.
d. Press the VARIATION button again (the indicator will go out).
EQUALIZER Layes ~~ @PUT 2 "GRAND 4 GRAND 2 -E.GRANO'’ MKS-20
Ce. GIG CI Ga eG
Sure LEVEL wanewamiont f RHODES’ €PANO HARE i
—
“REVERS
a
3. Select a Tone for the INT LOWER Part.
a. While holding down the LOWER button, press a Tone Selection button to select a Tone Group.
When only the LOWER button is lit, you can select the Tone Group by simply pressing the
relevant Tone Selection button.
Press the VARIATION button (the indicator will light).
Press the LOWER button (the indicator will flash).
Select the Tone number you want using the INC/DEC buttons or the VALUE slider.
Press the VARIATION button again (the indicator will go out).
ean s
16