Roland RD-500 - Pedal;C1 Slider and Controller Settings

DE NN a ASAI Se EIA I TEN NT RAE MEATY ON TIO RR IN a TEEN ES ENT NT RIS LETTS!
@ Setting the Pedal/Cl Slider
Using an expression pedal (or pedal switch) connected to the INT+TX PEDAL jack on the rear of the
unit, you can control the sound source of the RD-500. The VALUE slider (except when being used
for editing parameters), can be used as a C1 (control) slider for the sound source.
Use the following procedure and assign a function to the pedal or C1 (VALUE) slider. You can assign
different functions to each Part.
*
When
a
pedal
is
not
connected
to
the
TX
PEDAL
jack,
Control
messages
from
a
pedal
connected
to
the
INT+TX
PEDAL
jack will
be
transmitted
to
both
the
internal
sound
source
and
MIDI
OUT.
The
RD-500
also
allows
you
to
specify
what
messages
will
be
transmitted
to
the
MIDI
OUT.
(—
page 45)
° GRAND:1. GRAND 2 E.GRAND. Maxd-20).!
DUAL
ele ell
JE ARG ONE KEY TOUCH INDIGATOR.. LOCAL, BULK,
Level vartanbN: RHODES EmaNO SARE onGAN
FREMGLO VERS SESE. pelO DOWN. GENO UF
STRINGS." Gass PE
Ce
1. Select the Function mode.
2. Press the CONTROL button as many times as necessary to get the following display:
When setting the pedal When setting the C1 slider
rc"
| Pol | mae
3. Select the Part to be edited using the LOWER/UPPER button.
4. Select the desired function for the pedal or C1 slider using the INC/DEC buttons or the
VALUE slider.
} Volume
a Ou This determines the volume of a Part.
Pan
p A m This sets the pan (sound positioning) of a Part.
Damper
d f] P The sound can be sustained by depressing the pedal.
Soft
5 oO F The sound will become softer by pressing the pedal.
Sostenuto
This sustains the sound of notes which have been played
when the pedal is depressed.
WN mi) Wn
Reverb Switch
rT FE ‘ae This turns the Reverb effect on and off.
Chorus Switch
cE H Q This turns the Chorus effect on and off.
Tremolo Depth
E rc fl This determines the depth of the Tremolo effect.
Expression
FE P CT This controls Revolution(rotary speaker) effect or Harmonic
contents of a Tone in ORGAN Group. The same paremeter
controls the Cutoff frequency of a Tone in the other Group.
When the ier is returned to the original position or
when the C1 slider is set to the MIN position, the Cutoff
Frequency set with Bright{page 31) will be automatically called.
27