Roland RD-500 - Page 24

SSE SY FT LP aE SEN LE a NE)
24
* To edit a parameter for the INT LOWER or UPPER Part, select the UPPER or LOWER Part using
the UPPER or LOWER button.
. Change values of the selected parameter.
Use the INC/DEC buttons or the VALUE slider to change values.
* If you hold down the DEC or INC button, the value will change continueusly. Pressing INC while
holding down the DEC button (or vice versa) will cause the value to change more rapidly.
* It is also possible to enter a value directly with the Numerical Keys:
Specify the value first, then press the ENTER key.
For example, if you wish to set a value of 68,
Ce ae ee
bes press 6 ~ 8 ~ ENTER.
To enter a value of a positive(+) or negative(-) number, use
(ee
Cs) the A/B button before specifying a number with the
{ | Numerical keys. Each time you press the A/B button, +
{0 ] and - will be alternately selected.
SETUP MEMORY
. Repeat steps 2 and 3 as many times as needed.
. Leave the Function mode.
Press FUNC (the indicator will go out).
Poppe EorETeeT TET Te Tereeriterrrertertererereeritrerterretreettitirertettrit rit trerri treet ec
The editing procedure is explained in detail (in a subsequent section) along with
the explanation of each parameter.