Roland RD-500 - Page 61

eI PE EEE IE a a A a I I YE ES LE SOIT TE I a SISTED
{When Control Change #7 (Volume) is assigned to the C1 Slider or Pedal, check the position of
the Slider or Pedal. (page 27, 45)
@ The pitch is strange.
Qs the Transmit Transpose function for the TX LOWER/TX UPPER Part set correctly? (page
21,51)
O Check the Pitch Bender and its setting. (page 10)
QO When Bend Up/Down or Control Change #1 is assigned to the Pedal or C1 Slider, check the
position of the Pedal or Slider. (page 27,45)
@ Program Change/Bank Select messages cannot be output.
O Are Program Change/Bank Select set to OFF? (page 43,44)
QAre the LOWER/UPPER buttons (in the TX Control section) off? (page 41)
Qls the TX channel set correctly? (page 42)
@ When using a Sequencer
@ The sequencer will not record a performance.
OQ When the Local Switch is set to ON1, performance data of the INT LOWER/INT UPPER Parts is
not output through MIDI OUT. To record such data, set the Local Switch to ON2 or OFF. (page
34,39,40)
@ The channel on which data is recorded does not respond.
(Are the RX and TX channels set correctly? (page 34,42)
When the Local Switch is set to ON2 or OFF, performance data of the INT LOWER/INT UPPER
Part(s)
is
output
on
the
RX
channel,
and
data
of
the
TX
LOWER/TX
UPPER
Part(s)
is
output
on
the
TX
channel
through
MIDI
OUT.
To
record
only
the
performance
data
of
the
INT
LOWER/INT
UPPER Part(s), set the LOWER/UPPER button(s) (in the TX Control section) OFF. (page 39,40)
@ Sounds are doubled or played improperly.
OQ When the sequencer’s SOFT THRU function is on and the Local Switch of the RD-500 is set to
ON2, the internal sound module of the piano will sound twice. Set the Local Switch to OFF.
(page 34)
@ In the Multi Timbral Mode
@ No sound is heard.
Gls the RX channel of each Part turned OFF (0) ? (page 56)
Cils the RX channel of each Part set correctly? (page 56)
Ols the level of each Part set appropriately? (page 56)
Olf the RD-500 is not set to the Multi Timbral mode, only two Parts (INT UPPER and INT LOWER)
will be played. (page 55)
@ If the unexplained/inevitable occurs!
Olffwhen
something
unexpected
happens
—
like
someone
tripping
over
a
MIDI
cable,
thereby
disconnecting
it
right in
the
middle
of
your solo
—
the
RD-500
may
produce
some
really
strange
sounds!
When
this
happens
(and
it will!)
quickly
activate
the
PANIC
function;
press
the
FUNC
and
DEC
buttons
simultaneously.
This
will
instantly
kill
any
sound
the
piano
may
be
making.
(Remember:
in
a
crowded
club
this
function
may
be
your only
friend!)
61