Roland RD-500 - Playing the Roland RD-500: Basic Operation

m CONNECTIONS
RESET 55 Ra ee ; TKED NO). PHONES
DAMPER INT#TX” TX THRU OUT : ne :
Sut
MID! device (page 38)
Headphones
CP
seunsuecneneunbae,
Pedal switch
Mixer, MTR, etc.
Power amplifier
m@ Power On!
Make sure that the volume on the connected amplifier, mixer or stereo set is set to its minimum level,
then turn on the RD-500.
The following display appears :
Number of Setup memory
POWER
fl
=
[A-T
|
* Since the unit is equipped with a circuit protection device, it will be muted for a few seconds
even after it is switched on.