Roland SPD-SX PRO - Step Flanger

Effect List (English)
184
Step Flanger
This is a flanger in which the flanger pitch changes in steps.
The speed at which the pitch changes can also be specified in terms of a note-value of a specified tempo.
Parameter
Value
Explanation
Filter Type
OFF, LPF, HPF
Type of filter
OFF: No filter is used.
LPF: Cuts the frequency range above the Cutoff Freq
HPF: Cuts the frequency range below the Cutoff Freq
Cutoff Freq
200, 250, 315, 400, 500, 630, 800, 1000, 1250, 1600,
2000, 2500, 3150, 4000, 5000, 6300, 8000 [Hz]
Basic frequency of the filter
Pre Delay
0.0–100.0 [msec]
Adjusts the delay time from the direct sound until the
flanger sound is heard.
Rate (sync
sw)
OFF, ON
If this is ON, the rate synchronizes with the tempo of the
rhythm.
Ø KIT TEMPO(P.33)
Rate (Hz)
0.05–10.00 [Hz]
Frequency of modulation
Rate (note)
Note
Ø Note(P.203)
Depth (*1)
0–127
Depth of modulation
Phase
0–180 [deg]
Spatial spread of the sound
Feedback
-98–+98 [%]
Adjusts the proportion of the flanger sound that is fed back
into the effect. Negative (-) settings will invert the phase.
Step ()
OFF, ON
If this is ON, the rate synchronizes with the tempo of the
rhythm.
Step Rate
(Hz)
0.10–20.00 [Hz]
Rate (period) of pitch change
Step Rate
(note)
Note
Ø Note(P.203)
Low Gain
-15–+15 [dB]
Gain of the low range
High Gain
-15–+15 [dB]
Gain of the high range
Balance
D100:0W–D0:100W
Volume balance between the direct sound (D) and the
flanger sound (W)
Level
0–127
Output Level
*1: This parameter corresponds to MFX Ctrl. For details, refer to “De MFX bedienen met de PAD EDIT [1] [2]-regelaars (MFX
Ctrl)(P.204)”.
*1: This parameter corresponds to MASTER EFFECT CTRL. For details, refer to “Het MASTER EFFECT bedienen met de MASTER
EFFECT-regelaar (MASTER EFFECT CTRL)(P.205)”.