Roland SPD-SX PRO - Limiter

Effect List (English)
196
Parameter
Value
Explanation
M Post Gain
0–+18 [dB]
Adjusts the output gain.
S Comp
Switch
OFF, ON
Switches whether to adjust the sense of volume for left/right input signals whose signals are
considerably out of phase
S Attack
0–124
Sets the time from when the input exceeds the Threshold until the volume starts being
compressed
S Release
0–124
Adjusts the time after the signal volume falls below the Threshold Level until compression is no
longer applied.
S Threshold
-60–0 [dB]
Adjusts the volume at which compression begins
S Knee
0–30 [dB]
This is a function that smooths the onset of compression from the uncompressed state; it
gradually applies compression starting earlier than THRESHOLD. Higher values produce a
smoother transition.
S Ratio
1:1, 1.5:1, 2:1,
4:1, 16:1, INF:1
Compression ratio
S Post Gain
0–+18 [dB]
Adjusts the output gain.
Level
0–127
Output Level
*1: This parameter corresponds to MFX Ctrl. For details, refer to “De MFX bedienen met de PAD EDIT [1] [2]-regelaars (MFX
Ctrl)(P.204)”.
*1: This parameter corresponds to MASTER EFFECT CTRL. For details, refer to “Het MASTER EFFECT bedienen met de MASTER
EFFECT-regelaar (MASTER EFFECT CTRL)(P.205)”.
Limiter
Compresses signals that exceed a specified volume level, preventing distortion from occurring.
Parameter
Value
Explanation
Release
0–127
Adjusts the time after the signal volume falls below the Threshold Level until compression is no
longer applied.
Threshold
(*1)
0–127
Adjusts the volume at which compression begins.
Ratio
1.5:1, 2:1, 4:1,
100:1
Compression ratio
Post Gain
0–+18 [dB]
Adjusts the output gain.
Low Gain
-15–+15 [dB]
Gain of the low range
High Gain
-15–+15 [dB]
Gain of the high range
Level
0–127
Output Level
*1: This parameter corresponds to MFX Ctrl. For details, refer to “De MFX bedienen met de PAD EDIT [1] [2]-regelaars (MFX
Ctrl)(P.204)”.
*1: This parameter corresponds to MASTER EFFECT CTRL. For details, refer to “Het MASTER EFFECT bedienen met de MASTER
EFFECT-regelaar (MASTER EFFECT CTRL)(P.205)”.