Roland SX-12 - User Manual

SX-15/12/8
USER'S MANUAL
Thank you very much for purchasing the SX-15/12/8.
• To ensure correct and safe usage with a full understanding of this product's perfor-
mance, please be sure to read through this manual completely and store it in a safe
location.
• Unauthorized copying or transferral, in whole or in part, of this manual is prohibited.
• The contents of this operation manual and the specifications of this product are
subject to change without notice.
• The operation manual and the product have been prepared and tested as much as
possible. If you find any misprint or error, please inform us.
• Roland DG Corp. assumes no responsibility for any direct or indirect loss or damage
which may occur through use of this product, regardless of any failure to perform on
the part of this product.
• Roland DG Corp. assumes no responsibility for any direct or indirect loss or damage
which may occur with respect to any article made using this product.
This User's Manual is intended for SX-15, SX-12 and SX-8.

Summary

To Ensure Safe Use

About WARNING and A CAUTION Notices

Explains symbols used for warnings and cautions to prevent hazards.

About the Symbols

Details the meaning of specific warning and caution symbols in the manual.

Part 1 Introduction

1.1 Checking Accessories

Lists all items shipped with the unit to ensure completeness.

1.2 Part Names

Identifies and labels the different physical parts of the cutting unit.

1.3 Setting Up the SX

Instructions for setting up the SX unit, including installation space and cable connections.

1.4 Installing and Setting Up the Software

Guide to installing the Dr. STIKA PLUS software and drivers.

Part 2 Performing Cutting

2.1 Load the Material

Instructions for properly loading cutting material into the machine.

2.2 Creating Cutting Data

Steps for creating cutting data using Dr. STIKA PLUS software, including setting ranges and manipulating shapes.

2.3 Starting Cutting

Procedures to initiate the cutting process on the SX-15/12/8.

2.4 Applying Cut Material

Steps for applying cut material to a surface correctly.

Part 3 Mastering the SX

3.1 Adjusting and Replacing the Blade

Instructions for adjusting blade extension and replacing the blade for optimal cutting.

3.2 Setting the Tool Conditions

Guide to configuring tool settings for different Windows versions and materials.

3.3 Cutting Range

Details the cutting range specifications for SX-15, SX-12, and SX-8 models.

3.4 Changing Loaded Material Width on SX-15

How to adjust the SX-15 for narrower material widths and change driver settings.

3.6 Importing Windows Bitmap Format

Instructions for importing and preparing BMP image files for cutting, including data conditions.

3.8 Importing Scanned Objects

Guide to importing scanned images for cutting using Dr. STIKA PLUS.

3.9 Applying Large Material

Techniques for applying large cut materials without bubbles or misalignment using water and detergent.

Part 4 Users Reference

4.1 Care and Maintenance

Procedures for cleaning and maintaining the cutting machine.

4.2 Troubleshooting Common Issues

Troubleshooting guide for common operational issues and errors.

4.3 Product Specifications

Technical specifications for the SX-15, SX-12, and SX-8 models.

Output from Roland CutChoice

Information on using Roland CutChoice software with the SX series for outputting designs.

Roland SX-12 Specifications

General

Brand	Roland
Model	SX-12
Category	Cutter
Language	English