20
Apr.2005
Before Connecting
fig.test6.eps
After Connecting
fig.test7.eps
2. Disconnect the MIDI cable and confirm the signal is off (OFF-LINE OK);
the procedure automatically advances to the next test.
4. SW/LED Test [TEST - 4 SW&LED]
1. Press each panel switch one at a time; confirm that the switch name and
position appears in the display, and the corresponding sound plays.
Also confirm that the corresponding light goes off.
Example of the [EXIT] button being pressed
fig.test8.eps
LEDs with no corresponding switches are turned off with the following
switches.
TRIGGER LEDs: Turned off lights in red, green the order, by pressingthe [F1]
button
Left column of seven-segment LED: The dots are turned off one by one by
pressing the [F2] button
Center column of seven-segment LED: All of the dots go off simultaneously by
pressing the [F3] button
Right column of seven-segment LED: All dots go off simultaneously by
pressing the [F4] button
GROUP FADERS Upper LEDs: Turned off by the [+] button
GROUP FADERS Lower LEDs: Turned off by the [-] button
fig.test9.eps
2. If all tests result in “OK,” the procedure automatically advances to the
next test category.
If two or more switches are pressed simultaneously, the test is cancelled.
5. LCD/ENCODER Test [TEST - 5 LCD&ENCDR]
1. Slowly rotate the [VALUE] dial to the right.
2. Confirm that the arrow in the middle of the LCD display moves slowly to
the right, while the screen contrast darkens.
3. When the meter is rotated fully to the right, “RIGHT!” appears in the
display, and then changes to “OK!”
4. Next, slowly rotate the [VALUE] dial to the left.
5. Confirm that the arrow in the middle of the LCD display moves slowly to
the left, while the screen contrast lightens.
6. When the meter is rotated fully to the left, “LEFT!” appears in the
display,and then changes to “OK!”
fig.test10.eps
7. Next, press the [F1(DARK)] button.
Confirm all dots in the LCD are lit.
8. Next, press the [F1(BRIGHT)] button.
Confirm all dots in the LCD go off.
9. Press the [F5(OK)] button to advance to the next test.
6. LCD/OFFSET Test [TEST - 6 OFSET]
When the display of the LCD is thick or thin, please rotate the [VALUE] dial
for OFFSET of LCD is adjusted.
LCD is thick.
fig.test11-1.eps
LCD is thin.
fig.test11-2.eps
Rotate the [VALUE] dial,and adjusts it in the state to see the display easily.
1. Rotate the [VALUE] dial,and adjusts it in the state to see the display
easily.
fig.test11-3.eps
2. Press the [F5(OK)] button to advance to the next test.
7.SLIDER Test [TEST - 7 SLIDER]
1. Move each GROUP FADER up and down one at a time.
2. Confirm that when the FADER is all the way up, the corresponding value
in the LCD is “127,” and when the FADER is all the way down, the
corresponding value in the LCD is “0.
Also confirm that this is accompanied by the corresponding pitch
changes.
fig.test12.eps
3. When all FADER changes are detected, the procedure automatically
To Next Page
Loading...
