Roland TR-505 - 9 Other; Insert

9. Other Useful Functions
[
Track Editing
]
You may find on listening to your Track, that you iiave
made an error. The
TR-505
allows
you to
replace
the
wrong pattern in a certain bar with a correct one, add
or delete patterns,
etc. This
editing function, how-
ever,
requires you to assign the bar number correctly.
a. Assigning
a
Bar
There are two methods for assigning
a
bar number.
One is by using the Back Key and Fonvard Key, and
other is by using the Number Keys (Main Keys).
Using the Back and the
Forward Keys
Push the Forward Key
®
which advances one bar
at
a time as many times until you come to the right bar.
Push the Back Key
®
which backs up one bar at
a
time,
as
many times until
you come to
the right bar.
I
While holding the Shift Key down, assign the first
bar number you want to delete by using the Main
Keys.
1
While holding the Shift
Key
down, push the Delete
Key (Main Key
13),
assign the last bar number to
be deleted, then the Enter Key. (This is the same
operation
as
shown on
page 30.)
To delete up to the end of the Track, instead of
assigning the last bar number, push the Last Mea-
sure
Key
®
(with the Shift Key down, push the
Delete,
Last
Measure then Enter). (Refer to the
example shown on page
31
.)
To delete a single bar,
while holding the Shift Key
down, push the Delete, then the Enter."
(Refer
to
the
example shown on
page
32.)
Using the Number Keys (Main Keys 1 to
10)
Assign the bar number
by
holding the Shift Key down
while punching the bar number on the Main Keys 1 to
10 (press 1 and 6 for bar number
16),
and push the
Enter Key.
c. Insert
You can insert any single pattern or
block of patterns
into
a
Track,
(D
Enter the Track Writing mode.
b. Delete
You
can delete any pattern or series of patterns from
a
Track.
To delete a sequence of patterns, you assign
the first and last bars of the sequence before remov-
ing them from the Track.
®
Enter the Track Writing
mode.
'Assign the bar
number after which you wish to
insert
a pattern, by
pushing the appropriate
Main
Key while holding the Shift Key down.
®
Select the pattern you wish to
insert
by
using the
Pattern
Group Key
and the Main Key.
®
While holding the Shift Key
down, push the Insert
Key (Main Key
®),
then the
Enter Key. (Refer
to
the example shown on
page 33.)
*
You can also insert a block
of patterns. Assign the
first and the last bar
numbers of the block by
push-
ing the relevant Main Keys at a
time.
28