Roland TR-505 - Setting; Changing

To
change the Setting
of each MIDI
function, call the
MIDI function whose
setting you
wish
to
change,
and
go
to the
relevant
procedure (following a to e)
WITH
THE SHIFT KEY
STILL HELD
DOWN.
The
MIDI functions you
have set will be
retained even
when the
composer is switched
off.
a.
Setting MIDI
Sync
If you wish to
control the TR-505 with the
sync signal
from the external
device, push the Up Key
®,
and if
not, push Down Key ®.
With the Display
still showing the function.
D
DOWN
D
on
ut
When this
MIDI Sync is set to
ON, the TR-505
is con-
trolled by the
sync signal of
the external
device. This
can be
understood by
the indication
in the Display as
shown
right.
b. Setting
OMNI Mode
OMNI ON mode
makes the receiver
recognize voice
messages in
all channels without
discrimination. To
select this OMNI
ON mode, push the Up Key ®.
To
select the OMNI OFF
mode which makes
the
receiver recognize the messages
exclusively in the
set
receive channel, push the Down Key ®.
c.
Changing the Receive
Channels
To change to
the MIDI channel
number higher than
the current one, push the Up Key
®.
and to
decrease
the
number, push the Down Key ®.
(CH 1 to 16 are
available.)
With the Display still showing
the function.
While
holding
down
D
DOWN
in
on
With the Display still showing the function.
UP
^
1
1
DOWN
»
1 1
1 /
CSM
While
holding
down
tn
Z9