Storing Rhythm Patterns in External Mem
When the
TR-626
is
verifying,
the
tempo
indicator will light. Data
being
input
from the
Tape
In/Out
Jack
and
the original
data
in
Bank
1 arc being compared.
When the
data
has been verified
as
having
been correctly saved, the
TR
- 626 will
go
into
track
play mode.
*
If
you would like
to
suspend verifying push Main Key 1.
* If
the
signal was
transmitted
incorrectly
from
its
beginning,
or
if reading
it
becomes
difficult
at
some point the following error message will
appear:
,-
c ,- ,-
Errors
occur
largely
as
a result of
two
causes. One
is
that
the
volume
is
not
set
properly while verifying. In
this
case, simply
stop
the tape
recorder,
adjust
the reproduction level,
and
start
verifying once more
from·
the
beginning.
If
it has a tone control,
adjust
this also
if
it
seems
appropriate
to
do so.
The
second
cause
is
that
the
data
was
not recorded properly. In this case,
adjust
the recording level and
save
the
data
from
the
beginning,
that
is,
start
over
completely.
If
an
error
message
is
still indicated
after
the
above
procedure,
try
again using a different tape recorder.
73
To Next Page
Loading...
