Roland TR-626 - Page 116

MIDI Function
Step 2
Step 3
Step 4
86
SYNC mode : Determine whether the external MIDI device or the TR-626
itself will control the TR-626's tempo, starting, stopping, etc.
If the TR-626 is to be in control, carry out the procedure
above in Synchronization with the TR-626 acting as the
Master. If not do as below.
Set the TR--626's OMNI to OFF. (Refer to "Altering OMNI mode"
on p.83.)
The master device's transmission channel and the TR-626's reception
channel are usually set to different numbers. However, they can be
set the same if you would like to play the TR-626's drum voices
with the performance information sent from the master device as well
as with the TR-626's own data. (Refer to "Altering the reception
channel" on p.83.)
When the master device begins to play, the TR - 626 will begin
playing synchronously with it.