Roland TR-626 - Page 75

Tape SYNC
2. Synchronized playing with sync signal
Step 1
Step 2
Synchronize the TR-626 with a tape-recorded synchronized signal to
have it start playing,
Connect the TR - 626 to the MTR as shown below :
IN IN LINE OUT
TAPE
SYNC IN
L R(MONO)
TR-626
Rewind the tape onto which the synchronized signal was recorded.
Find the part of the tape just after where the constant sound begins.
This is the place from which to begin.
Set the TR-626 on Tape SYNC mode. (See p.87.)
MODE
,-
L Cl
TRACK PLAY
=,,,c
LI
EXT SYNC
Start the MTR playing.
95