Roland V-Drums TD-27 - Performing Along with a Song - Smartphone; Connecting via MIX IN Jack; Wireless Connection via Bluetooth; Playing Songs from Smartphone

13
Getting Ready
Making Hi-Hat Settings
If you’re using the hi-hat (VH-10/VH-11 or VH-13), adjust the oset on the TD-27.
This adjustment is required for hi-hat pedal movements such as open or close to be detected correctly.
&If you want to make ne adjustments to the hi-hat sensitivity etc., refer to “Adjusting the Pad Sensitivity (PARAM)” (p. 52).
Settings for the VH-10 / VH-11
1. With the hi-hat completely separated from the
motion sensor unit, power-on the TD-27.
motion sensor unit
Separated
clutch screw
2. Loosen the clutch screw and let the hi-hat rest
naturally on the motion sensor unit.
3. Press the [SYSTEM] button.
4. Use the cursor buttons to select “TRIGGER,”
and press the [ENTER] button.
5. Use the cursor buttons to select “HI-HAT,” and
press the [ENTER] button.
The TRIGGER HI-HAT screen appears.
6. Use the dial to set the Trig Type to “VH10.”
7. While reading the
meter displayed
on the right side of
the TD-27’s screen,
adjust the oset
with the VH-10’s oset adjustment screw.
Adjust the oset so that the appear in the meter.
Changes
from “ ”
to “
AC
”
8. Fasten the clutch screw at a position where the
hi-hat sways naturally when struck.
9. Press the [DRUM KIT] button to return to the
DRUM KIT screen.
Settings for the VH-13
1. Press the [SYSTEM] button.
2. Use the cursor buttons to select “TRIGGER,”
and press the [ENTER] button.
3. Use the cursor buttons to select “HI-HAT,” and
press the [ENTER] button.
The TRIGGER HI-HAT screen appears.
4. Use the dial to set the Trig Type to “VH13.”
5. Press the [F5] (OFFSET) button.
The VH OFFSET ADJUSTMENT screen appears.
6. Loosen the clutch screw of the top hi-hat and
let it sit on the bottom hi-hat.
* Do NOT touch the hi-hats or the pedal.
7. Press the [F5] (EXECUTE) button.
The “VH Oset” parameter is set automatically (approx. 3
seconds).
8. Press the [DRUM KIT] button to return to the
DRUM KIT screen.
OPEN
CLOSE
oset
adjustment
screw