Getting Ready
9
Turning the Power On/O
* Once everything is properly connected (p. 8), be sure to follow the procedure below to turn on their power. If you turn on equipment in the
wrong order, you risk causing malfunction or equipment failure.
* Before turning the unit on/o, always be sure to turn the volume down. Even with the volume turned down, you might hear some sound when
switching the unit on/o. However, this is normal and does not indicate a malfunction.
Turning the TD-50X On
1. Minimize the volume of the TD-50X and the
connected devices.
2. Press the TD-50X’s [L] switch.
When you turn the TD-50X on, the following screen appears.
In this screen you can enable or disable the Auto O function.
Button Explanation
[F1] (OFF) button The power does not turn o automatically.
[F4] (4 HOURS) button
When four hours have elapsed without
any pad being struck or any operation
being performed, the unit will turn o
automatically.
If the Auto O function is set to “OFF,” this screen won’t appear.
MEMO
If a pad that supports digital connection is connected, the pad
setting screen might appear. For details, refer to “Settings for pads
that support digital connection” (p. 7).
3. Power-on the connected devices, and adjust the
volume.
Turning O the Power
NOTE
Settings that you edit on the TD-50X are saved when you turn o
the unit. Be sure to turn o the unit by pressing the [L] switch.
1. Minimize the volume of the TD-50X and the
connected devices.
2. Turn o the power to the connected devices.
3. Press the TD-50X’s [L] switch.
The screen will indicate “Please wait. Now saving...,” and the unit will
turn o when the settings have been saved.
* If you need to turn o the power completely, rst turn o the unit,
then unplug the power cord from the power outlet. Refer to “To
completely turn o power to the unit, pull out the plug from
the outlet” (p. 2).
To Next Page
Loading...
