Roland VERSELAB MV-1 - Recording CTRL Knob Movement in Steps (Motions); Assigning Parameters to the CTRL Knobs; Setting a Motion to On;Off; Deleting a Motion

29
Recording CTRL Knob Movement in Steps (Motions)
You can make changes to the sound by recording your operations of the [CTRL 1]–[CTRL 3] knobs as “motions.”
* Motions can’t be recorded on the VOCAL track.
* Motions can be recorded for each clip.
Assigning Parameters to the CTRL Knobs
You’ll need to assign the parameters you want to record to the
[CTRL 1]–[CTRL 3] knobs.
& For detailed information, refer to “Assigning Parameters to the CTRL
Knobs” (p. 43).
Setting a Motion to On/O
For each clip, you can specify whether a motion is played back.
When the motion is turned on, the [CTRL 1]–[CTRL 3] knobs recreate
the motions when playing back performance data.
1. Follow the steps in “Selecting a Clip” (p. 19) to select the
clip.
2. Press the [MOTION] button to make it light.
The motion turns on.
3. Press the [MOTION] button to make it go dark.
The motion turns o.
Recording Motions
Here’s how to record your operating the [CTRL 1]–[CTRL 3] knobs to
steps that are playing back.
* You can’t record motions when the CTRL knobs are used to display a screen
for operating parameters, such as the track mixer screen.
1. Follow the steps in “Selecting a Clip” (p. 19) to select the
clip to which you want to record the motion.
2. Press the [REC] button to enter record standby.
3. Press the [
A
] (START/STOP) button to play back the
performance data.
Motion recording begins.
4. Turn the [CTRL 1]–[CTRL 3] knobs.
Knob operations are recorded at each step.
5. Press the [REC] button to make it go dark.
Motion recording ends.
6. Press the [
A
] (START/STOP) button to stop playback.
Deleting a Motion
1. Follow the steps in “Selecting a Clip” (p. 19) to select the
clip whose motion you want to delete.
2. Press the [EDIT] button, and then press the [MOTION] button.
The MOTION MENU screen appears.
3. Use the [VALUE] dial to select “CLEAR ALL,” and then press the
[VALUE] dial.
* To delete motions for the respective knobs, select “CLEAR CTRL 1”–”CLEAR
CTRL 3.”
A conrmation message appears.
* To cancel the operation, press the [EXIT] button.
4. Use the [VALUE] dial to select “OK,” and then press the
[VALUE] dial.
The motion is deleted.
Editing a Motion
You can edit motions that you’ve recorded for each step.
1. Follow the steps in “Selecting a Clip” (p. 19) to select the clip.
2. Press the [EDIT] button and then the STEP SEQUENCER [1]–
[16] buttons to select the steps whose motions you want to
edit.
3. Press the [MOTION] button.
The motion value appears.
4. Turn the [CTRL 1]–[CTRL 3] knobs to adjust the value.
5. When you have nished editing, press the [EXIT] button.