Roland VERSELAB MV-1 - Editing a Vocal Sequence; Adjusting the Vocal Start Timing; Deleting a Vocal Sequence

38
Recording the Vocals
Editing a Vocal Sequence
You can edit vocal sequences to adjust where the singing should start or to add repeating backing vocals.
Adjusting the Vocal Start Timing
1. Press the [SONG] button to set the workow to “SONG.”
2. Press the [VOCAL] button to select the VOCAL track.
3. Press the [EDIT] button, and then press pads [1]–[16] to select
the vocal take to edit.
The TAKE EDIT MENU screen appears.
4. Use the [VALUE] dial to select “TAKE SEQ EDIT,” and then press
the [VALUE] dial.
The vocal sequence edit screen appears.
Vocal sequence number
Vocal start point
Measure–beat–take
Vocal end point
Measure–beat–take
5. Use the [VALUE] dial or the [CTRL 1] knob to select the vocal
sequence to edit.
6. Adjust the vocal start point using the [CTRL 2] knob, and the
vocal end point using the [CTRL 3] knob.
Adding a Vocal Sequence
1. Press the [SONG] button to set the workow to “SONG.”
2. Press the [VOCAL] button to select the VOCAL track.
3. While holding down the pad [1]–[16] corresponding to the
vocal take you want to play, press the STEP SEQUENCER [1]–
[16] button corresponding to the position where you want to
add the start point.
The vocal sequence is added.
Press the [VALUE] dial to display the vocal sequence edit screen.
This lets you check the start/end points for the vocal sequences you
add.
Deleting a Vocal Sequence
1. Press the [SONG] button to set the workow to “SONG.”
2. Press the [VOCAL] button to select the VOCAL track.
3. Press the [EDIT] button, and then press pads [1]–[16] to select
a vocal take.
The TAKE EDIT MENU screen appears.
4. Use the [VALUE] dial to select “TAKE SEQ EDIT,” and then press
the [VALUE] dial.
The vocal sequence edit screen appears.
5. Use the [VALUE] dial or the [CTRL 1] knob to select the vocal
sequence to delete.
6. Press the [CLEAR] button.
A conrmation message appears.
* To cancel the operation, press the [EXIT] button.
7. Use the [VALUE] dial to select “OK,” and then press the
[VALUE] dial.
The vocal sequence is deleted.