118
Chapter 8 EZ Routing
fig.02-35
13.Press [F2 (STEP ->)]. You can return to the previous screen by pressing [F1 (STEP<- )].
14.Select the Master Section settings. Use [ ], [ ], [ ], and [ ] to move the cursor and the TIME/VALUE dial to
adjust each of the values.
fig.02-36
15.Press [F4 (Exec)]. “EZ ROUTING Step Edit is finished!!” appears in the display.
fig.02-24a
WARNING: EZ Routing settings will override any existing mixer settings you have already made.
16.You can save your setup as an EZ Routing template, or Exit [F6 (EXIT)] to leave this display without saving. To save the setup,
press [F3 (SAVE)]. The Routing Save screen appears in the display. Save the setup using the procedure described in "Saving an
EZ Routing Template," p. 121.
AUX Switch
AUX Send Level
AUX Send Pan/
Balance
Cursor
Monitor Select
Equalizer Mode
Direct Out
Effect Insert
To Next Page
Loading...
