171
Chapter 13 CD-RW and Mastering
Chapter 13
Mastering Tracks Status
Shortcuts
Shortcut 1
1. Press [MASTER].
2. Press [PAGE] so that [F6] indicates “M.Tr,” and then
press [F6 (M.Tr)].
3. Select the status of the mastering tracks. Make sure that
the cursor is located at “Stat,” and then turn the
TIME/VALUE dial.
4. Select the mastering V-Tracks. Use [ ] or [ ] to
move the cursor to “L:” or “R:,” and turn the TIME/
VALUE dial to select the desired V-Track.
Shortcut 2
The “Status” of the mastering tracks can also be set as
follows.
1. Press [PLAY (DISPLAY)].
2. Press [PAGE] so that [F6] indicates “M→***” (*** is either
Rec, Ply, or Off).
fig.2-11
3. The mastering tracks can be turned off, or set to record or
play back. [F6] toggles between these settings. The
indicator above [F6] shows the setting that will be
selected when you next press [F6], as indicated by an
arrow. The current status of the mastering tracks can be
viewed in the level meter in the display. For this
example, press [F6] until “M→Off” appears above [F6].
Press [F6] once more to select this setting.
fig.2-12.e
Off Record wait Status Playback Status
To Next Page
Loading...
