Roland VS-1680 - [F2 (EFX2)] Effect 2 Send; [F3 (EFX3)] Effect 3 Send; [F4 (EFX4)] Effect 4 Send; [F5 (AUX)] AUX Send

86
Chapter 6 Mixer Channel Strip Detail
[F2 (EFX2)] Effect 2 Send
Channel settings for the EFFECT 2 Bus. Sets the Effect Send
Switch, the Send Level (0-127) and panning.
Sw (Effect Send Switch)
Switches the channel to the EFFECT bus.
Off:
The channel is not sent to the EFFECT bus.
Pre:
The signal is sent to the EFFECT bus before it passes
through the mixer fader.
Post:
The signal is sent to the EFFECT bus after it passes
through the mixer fader.
Level
Sets the send level (0-127) of the signal sent to the EFFECT 2
Bus.
Panning
Sets the panning (L63-R63) of the signal sent to the EFFECT 2
Bus.
[F3 (EFX3)] Effect 3 Send
Channel settings for the EFFECT 3 Bus. Sets the Effect Send
Switch, the Send Level (0-127) and panning.
Sw (Effect Send Switch)
Switches the channel to the EFFECT bus.
Off:
The channel is not sent to the EFFECT bus.
Pre:
The signal is sent to the EFFECT bus before it passes
through the mixer fader.
Post:
The signal is sent to the EFFECT bus after it passes
through the mixer fader.
Level
Sets the send level (0-127) of the signal sent to the EFFECT 3
Bus.
Panning
Sets the panning (L63-R63) of the signal sent to the EFFECT 3
Bus.
[F4 (EFX4)] Effect 4 Send
Channel settings for the EFFECT 4 Bus. Sets the Effect Send
Switch, the Send Level (0-127) and panning.
Sw (Effect Send Switch)
Switches the channel to the EFFECT bus.
Off:
The channel is not sent to the EFFECT bus.
Pre:
The signal is sent to the EFFECT bus before it passes
through the mixer fader.
Post:
The signal is sent to the EFFECT bus after it passes
through the mixer fader.
Level
Sets the send level (0-127) of the signal sent to the EFFECT 4
Bus.
Panning
Sets the panning (L63-R63) of the signal sent to the EFFECT 4
Bus.
[F5 (AUX)] AUX Send
Channel settings for the AUX Bus. Sets the AUX Send Switch,
the Send Level (0-127) and panning.
Sw (Effect Send Switch)
Switches the channel to the AUX bus.
Off:
The channel is not sent to the AUX bus.
Pre:
The signal is sent to the AUX bus before it passes
through the mixer fader.
Post:
The signal is sent to the AUX bus after it passes through
the mixer fader.
Level
Sets the send level (0-127) of the signal sent to the AUX Bus.
Panning
Sets the panning (L63-R63) of the signal sent to the AUX Bus.
If you are not using VS8F-2 Effect Expansion Boards, the
Effect Send parameters will be replaced with additional AUX
send busses.
[F1 (Ef1In)] Effect 1 Insert
After pressing [F1 (EFX1In)], or moving the cursor to the
EFXIns area, press [ENTER] (see "Effect Types," p. 99).
EFX1 (Effect Insert Switch)
This sets how the effect is connected in the mixer.
Off:
The effect is not inserted in the channel.