181
Chapter 13 CD-RW and Mastering
Chapter 13
CD Player Function
You can use the CD-R/CD-RW drive to play a partially
recorded CD-R disc—a disc which has not been finalized (see
p. 176)—or to listen to commercially recorded CDs. To listen
to partially recorded CD-R discs, use the CD Player function.
* You can listen to the contents of the disc only through the VS-
1680’s MASTER output, MONITOR output, or from the
PHONES jack. You cannot output the audio from the CD-R/
CD-RW headphone jack or AUDIO OUT jacks.
1. Insert the partially recorded CD-R disc or a pre-recorded
commercial CD into the CD-R/CD-RW drive.
2. Press [PLAY (DISPLAY)].
3. Hold [SHIFT] and press [F1 (SONG)]. The Song Menu
icon appears in the display.
4. Press [PAGE] so “CDPly” appears in the display above
[F4].
5. Press [F4 (CDPly)].
The CD Player screen appears in the display.
Information is displayed as shown in the following:
fig.07-07
Only the following buttons, knobs, and faders can be
used in the CD Player function.
[ZERO]:
Goes to the start of the first song.
[REW]:
Rewinds as long as the button is held down.
[FF]:
Rapidly advances as long as the button is held down.
[STOP]:
Stops the CD.
[PLAY]:
Begins playback from the present location.
[PREVIOUS] or [ ]:
Returns to the beginning of the previous song.
[NEXT] or [ ]:
Advances to the beginning of the next song.
MASTER Fader:
Adjusts the overall volume.
MONITOR Knob:
Adjusts the volume output from the MONITOR jacks.
PHONES Knob:
Adjusts the headphone volume.
* When using the CD Player function, the transport control
buttons do not control standard VS-1680 transport functions.
* The audio playing from the CD-R/CD-RW drive cannot be
recorded back into the VS-1680.
* When listening to a partially recorded CD-R, the last 0.5
second (approximate) of the song cannot be played back until
the disc is finalized.
6. In the CD Player screen, the function buttons perform as
described below.
[F3 (Eject)]:
Ejects the CD-R/CD-RW tray.
[F5 (SelDr)]:
If more than one CD-R/CD-RW drive is connected to the
VS-1680, you can choose another drive to use.
[F6 (EXIT]:
Exits the CD Player screen and returns to the Song Menu
icon.
7. Use [ ] and [ ] to move the cursor to the CD
track you want to hear.
8. Press [PLAY] to begin CD playback.
9. Press [STOP] when you are finished with the CD Player
function.
10.Press [PLAY (DISPLAY)] to return to the Playlist display.
Song currently being performed
Total number of songs on the disc
Disc type (finalized/not finalized)
Total running time
Total number of tracks
Current play time
If “Please Insert Disc!” Appears in the
Display
This indicates the CD-R/CD-RW drive loading tray is
open, that there is no disc loaded, or the CD-R/CD-RW
drive is not ready for use. Insert a CD-R disc, wait a few
moments for the CD-R/CD-RW drive to read the disc,
and then press [YES].
To Next Page
Loading...
