228
Chapter 18 CD Backup
CD-R Backup
1. Select the drive (internal IDE hard drive) containing the
source song to be backed up as the current drive.
2. Place a blank CD-R/CD-RW disc in the CD-R/CD-RW
drive.
3. Press [PLAY (DISPLAY)].
4. Hold [SHIFT] and press [F6 (UTILITY)]. The Utility
Menu icon appears in the display.
5. Press [PAGE] so “CDRBk” appears in the display above
[F2]. Press [F2 (CDRBk)].
6. Mark the songs you want to back up. Use the TIME/
VALUE dial to move the cursor to the song you want to
back up, and then press [F3 (MARK)]. You can choose
more than just one song to backup. By pressing [F2
(ALL)], all songs will be marked for backup.
fig.07-14
7. Press [F1 (SelSg)] to display a directory of songs.
fig.07-15
8. From the song directory, press [F1 (Back)].
9. If several CD-R/CD-RW drives are connected to the VS-
1680, you can press [F5 (SelDr)] to display a directory of
drives. From this screen, use [ ], [ ], [ ], and
[ ] to select the CD-R/CD-RW backup destination
drive, then press [F1 (Back)].
fig.07-06
10.Press [F4 (Exec)]. “Backup to CD-R (SCSI2) Sure ?”
appears in the display.
11.Press [YES]. (Or, press [NO] to cancel the operation.)
12.“Store Current ?” appears in the display. Press [YES] to
store changes made to the current song, or press [NO] if
you don’t want to save changes made to the current
song. If the current song is a demo song, press [NO].
13.If the song or selected songs data will not fit on a single
CD-R/CD-RW disc, the first disc is ejected and the
message “Insert Disc #” (# indicating the next disc
number in the sequence) appears in the display. Insert
another blank CD-R/CD-RW disc and press [YES]. Write
the disc numbers on the labels using a permanent-ink,
If you are using a finalized CD-RW disc that contains
data, “Erase?” appears in the display. To erase the
existing data, press [YES]. “Erase Disc” appears and the
contents of the CD-RW disc are erased. If you do not
wish to erase the data, press [NO], and insert a new disc.
To Next Page
Loading...
