Roland VS-1680 - Page 132

132
Chapter 9 Automix
3. Press [PAGE] so that [F5] indicates “A.Mix,” and then
press [F5 (A.Mix)].
fig.4-02
4. Press [F2 (Micro)].
5. Press [PAGE] so that [F1] indicates “In.”
fig.4-03
6. Make sure that the cursor is located at “Edit Target,” and
use the TIME/VALUE dial to select the type of Automix
data that you wish to edit.
7. Use [ ] and [ ] to move the cursor to the first
marker of the area from which you wish to copy
Automix data, and press [F1 (In)].
8. Use [ ] and [ ] to move the cursor to the last
marker of the area from which you wish to copy
Automix data, and press [F1 (Out)]. A checkmark will be
added to the copy area.
fig.4-04.e
Even if there is only one marker for the Automix data that
you wish to copy, press [F1 (In)] and then [F1 (Out)] for the
desired marker.
You can turn the TIME/VALUE dial to modify the Automix
setting value at the cursor location. If you wish to re-select
the Automix data that will be copied, press [ ].
9. Press [F3 (Copy)].
10.Use [ ], [ ], [ ], and [ ] to move the
cursor. Turn the TIME/VALUE dial.
fig.4-08
Target
This will indicate the type of Automix data that you selected
to be copied in Step 6. If you wish to copy all Automix data,
use the TIME/VALUE dial to select “All Level and Pan.”
Destination Target
Select the copy destination for the Automix data.
There is no limitation on the copy-source and copy-
destination data. For example, you can copy the volume level
data (0–127) from a track and overwrite it onto the pan data
(L63–0–R63). However, if you do so, the results may not be
what you expect.
Check marks