Roland VS-1680 - Page 240

240
Chapter 20 Compatibility with Other VS Recorders
1. Make connections as shown below.
fig.10-01
2. Insert the Zip disk on which a VS-880/880EX/840/
840EX song has been recorded.
3. Select the internal drive (IDE hard drive) so that it is the
current drive (see "Drive Select," p. 222).
4. Press [PLAY (DISPLAY)].
5. Hold [SHIFT] and press [F1 (SONG)]. The Song Menu
icon is displayed.
6. Press [F4 (Imprt)]. If you do not see “Imprt” in the
display above [F4], press [PAGE] until you see “Imprt,”
and then press [F4 (Imprt)].
fig.10-01a
7. Press [F1 (SelDr)]. A list of drives appears in the display.
8. Press [ ], [ ], [ ], and [ ] to select the
source drive, and use the TIME/VALUE dial to select the
source drive partition. Then press [F1 (Back)].
fig.10-02
9. Use the TIME/VALUE dial to move the cursor to the
song you want to import and press [F4 (Mark)]. When
[F3 (All)] is pressed, you can place or remove marks from
all songs. By pressing [F2 (SelSg)], you can view a
directory of available songs.
fig.10-03
From this screen, select the songs you want to import by
pressing [F3 (Mark)]. Then press [F1 (Back)].
10.Press [F5 (Exec)]. A confirmation message appears in the
display.
11.Press [YES]. “STORE Current ?” appears in the display.
12.Press [YES] if you want to save changes made to the
current song; otherwise press [NO]. (If the current song
is a demo song, press [NO].) After Song Import is
completed, the screen returns to the Playlist display. The
song imported for use by the VS-1680 becomes the
current song.