56
Chapter 4 Recording Operations
3. Adjust the input sensitivity with the INPUT knob for each input. Provide a strong input signal by having instrument volumes
as high as possible. Raise the INPUT level as high as possible without having the PEAK indicator light up. The level meters
should show signal peaking between -12 dB and 0 dB.
4. Press [REC]. The button indicator blinks red.
5. Press [PLAY]. The button indicator lights green, and recording starts.
6. When the performance, and recording, is finished, press [STOP].
7. To listen to the recorded performance, press [ZERO] to return to the beginning of the song.
8. Press [PLAY] to begin playback of the song.
9. Use the channel faders and the Master fader to adjust channel volumes to an appropriate volume.
10.If you are satisfied with the results of your recording, save the song using the procedure described in "Saving a Recorded
Performance (Song Store)," p. 58.
Sources Assigned to Tracks
In a newly created song, the inputs are assigned to tracks as shown below. This is the default mixer routing.
fig.03-05a
To Next Page
Loading...
