4—VGA Main Display Universal Elements
Roland VS-2000 Owner’s Manual, Version Two Addendum www.RolandUS.com 33
The Mastering Room
When you select MASTERING ROOM from the CD-RWMASTERING menu, the
Mastering Room (
Owner’s Manual
Page 359) replaces the meters strip.
Use the EFFECT INSERT matrix to insert effects on the MASTER bus.
•
To activate an insert effect
—click its switch so that it turns yellow and a blue box
showing its currently selected effect patch appears in the insert matrix. The matrix
shows how signal flows from one inserted effect processor to the next.
•
To adjust the send to or return from an insert effect
—drag
its blue insert send or return slider, respectively, up
or down to set the send or return level as desired.
•
To select a new effect patch or edit the current patch
—click on the effect’s blue box in the
matrix to display the processor’s Algorithm View screen (
Owner’s Manual
Page 219).
You’ll want to use one of the Mastering Tool Kit (MTK) effect patches. Select an odd-
numbered processor since each powerful MTK patch requires an odd-numbered
processor as well as its even-numbered partner.
If a processor is unavailable because it’s already in use as an insert effect elsewhere, its
switch shows the name of the channel on which it’s inserted, as shown above.
If an even-numbered processor is being used by an MTK effect, it can’t be selected a
separate insert effect.
EFFECT INSERT controls
Insert switches
and meters
Insert matrix
In this illustration:
• FX 1 is already inserted on Input Channel 1, as its switch shows.
• only one optional VS8F-2 and/or VS8F-3 board is installed, so Effects 5 and 6 are
unavailable.
Insert send slider
Insert return slider
VS2000v2Add.book 33 ページ ２００５年４月８日 金曜日 午後２時２４分
To Next Page
Loading...
