5—VGA Main Display Home Screen
50 www.Roland.com Roland VS-2000 Owner’s Manual, Version Two Addendum
The Playlist’s Measure Bar
Just above the playlist is a gray strip called the “measure bar.” The lines in the bar show
the project measures as defined by the project tempo map (
Owner’s Manual
Page 296).
The time bar also contains markers, CD track markers, edit point flags, punch points
and loop points.
You can place any of these items at the desired locations using onscreen tools. To learn
how to place:
•
markers
—see “TAP” on Page 38.
•
edit points
—see Page 52.
•
Auto Punch points
—see Page 36.
•
loop points
—see Page 37.
You can:
•
reposition an object in the measure bar
—by moving your cursor over the object so the
cursor becomes a pointing finger, and then dragging to the desired new location.
•
clear an object in the measure bar
—holding down CLEAR on the VS-2000, positioning
the mouse cursor over the object until it turns into a pointing finger, and then
clicking the object.
The Measure Bar Pop-Up Menu
Use the measure bar pop-up menu to quickly place:
• edit points • Auto Punch IN or OUT points
• loop FROM or TO points • markers
• CD track markers
Right-click in the measure bar at the desired time location and select the object you
want from the measure bar pop-up menu.
To delete all markers and CD track markers from a project, select Clr All MARKER
from the measure bar pop-up menu.
Marker
Auto Punch Points Loop Points
Edit Points
IN OUT FROM TO
Punch in Punch out Loop endLoop start
When Auto Punch is on, a red bar
connects the red punch points.
When looping is on, a blue loop box
connects the blue start and end points.
CD Track Marker
(Red) (Green)
Gold Blue
VS2000v2Add.book 50 ページ ２００５年４月８日 金曜日 午後２時２４分
To Next Page
Loading...
