Roland VS-2000 - Page 37

4—VGA Main Display Universal Elements
Roland VS-2000 Owner’s Manual, Version Two Addendum www.RolandUS.com 37
11. LOOP
12. ABS/REL Indicator
13. SCRUB
14. PREVIEW Buttons
15. Position Bar
16. Transport Buttons
Click LOOP to display the AUTO PUNCH/LOOP window in which you
can set loop start and end points. If the loop points have been set, click
this button to turn on looped playback of the VS-2000’s hard disk
recorder.
Loop start and end points appear above the Home screen’s playlist as blue arrows.
When looping is turned on, a blue loop box connects the two points. See Page 50.
The Current Time Location display can show absolute project time
(ABS), or can shift the time to correspond to an external device to which
the VS-2000 is being synchronized (REL).
Click SCRUB to repeatedly audition a tiny fragment of audio at the
timeline’s current location in order to pinpoint a recorded event.
When you’re trying to locate the precise time at which an audio event
occurs, click the appropriate PREVIEW button to listen to audio just
before and/or after the current position of the timeline.
Click and drag the position bar’s handle to move to any location in a
project. The position of the handle shows you where you are in a project.
Click:
• ZERO —to return the timeline to the start of the project.
• Rewind —to move the timeline quickly back through the project.
• FF —to move the timeline quickly forward through the project.
• STOP —to halt playback of the project.
• PLAY —to begin playback from the timeline’s current location.
• REC —to begin recording.
178
300
181
PREVIEW
FROM
PREVIEW
TO
PREVIEW THRU
180
Handle
126
RECZERO
Rewind STOP
FF PLAY
Rewind and FF can
move the timeline in
increments as small as
one second.
175
VS2000v2Add.book 37 ページ ２００５年４月８日 金曜日 午後２時２４分