8—VGA Main Display EZ ROUTING Screen
78 www.Roland.com Roland VS-2000 Owner’s Manual, Version Two Addendum
Routing Signals to a Recording Track Using a Mouse
The procedures for routing a signal from an input channel, track channel, FX return
channel, Aux bus or Direct path to a recording tracks are the same, and take place in
the TRACK ASSIGN EZ ROUTING pane.
To make a new connection:
1. Position the mouse cursor over the connection node you want to route to the track.
2. Click and drag the mouse to the desired recording track—a virtual cable appears
onscreen to show the connection you’re making.
To change or delete an existing connection:
1. Position the mouse cursor over the desired recording track until the cursor changes
to a pointing finger.
2. Click and drag the mouse left or right to select a new track or all the way left to
delete the connection.
Routing Signals to Outputs Using a Mouse
You can route any busses or tracks to the desired output jacks or connectors in the
OUTPUT ASSIGN pane using the same principles described on
Owner’s Manual
Page 274.
To make or break a connection in the OUTPUT ASSIGN pane, position the mouse
cursor over the desired connection node and drag upward or downward as desired.
Recording Bus Attenuation
The REC BUS ATT knob in the OUTPUT ASSIGN pane allows you to adjust
the overall recording level to all tracks at once, as described on
Owner’s Manual
Page 275. This can be helpful when bouncing, and should otherwise be set to
-6.0dB.
VS2000v2Add.book 78 ページ ２００５年４月８日 金曜日 午後２時２４分
To Next Page
Loading...
