EasyManua.ls Logo

Roland VS-2000 - Page 49

Roland VS-2000
88 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5—VGA Main Display Home Screen
Roland VS-2000 Owner’s Manual, Version Two Addendum www.RolandUS.com 49
17. DIR (DIRECT) 1-8 Selector
18. MIX Button
19. AUX and FX Send Controls
The AUX and FX send controls include the following parameters:
Send level
—drag a slider to set the track channel’s Aux and FX send level to the
corresponding Aux and FX bus (See
Owner’s Manual
Page 150). The send level appears
to the right of the slider in dB. When Aux and FX busses are linked, the even-
numbered bus’s send control is replaced by a panning handle, described on Page 73.
Send status
—turns the Aux and FX send to each bus on or off. See
Owner’s Manual
Page 150.
Pre/post switch
—sets the pre or post configuration of each Aux and FX bus. See
Owner’s Manual
Page 89.
The color of each Aux bus’s and FX bus’s slider provides helpful information at a
glance. When a slider’s:
blue
—the send is turned on and the bus is set to Post.
red
—the send is turned on and the bus is set to Pre.
gray
—the send is turned off.
When odd/even Aux busses are linked, the even-numbered
bus’s slider is replaced by a panning handle, as described on Page 73.
20. Status Toggles
Beneath the track control areas are five status
toggle buttons. You can click each button to
toggle the setting of the entire column of
buttons directly above it.
To assign the track channel to a Direct path, click the desired Direct
path’s number so it lights.
Turn MIX on to send the track channel’s signal into the MASTER
bus, the main stereo mix. Turn it off to remove it from the mix.
When you change an Aux and FX bus’s pre/post setting, you’re setting the pre/post
configuration of the Aux bus for any channel that’s using it, as described on
Owner’s
Manual
Page 150.
Click this status toggle: To:
MUTE un-mute all currently muted tracks.
SOLO un-solo all currently soloed tracks.
AUTOMIX STATUS set the status of all Automix tracks to the same value.
TRACK STATUS set the TRACK STATUS of all tracks to the same value.
154
152
Send level
Send status
Pre/post switch
AUX Send
FX Send
VS2000v2Add.book 49 ページ 2005年4月8日 金曜日 午後2時24分

Table of Contents

Other manuals for Roland VS-2000

Related product manuals