Roland VS-2000 - Page 48

5—VGA Main Display Home Screen
48 www.Roland.com Roland VS-2000 Owner’s Manual, Version Two Addendum
8. FADER (LEV) Slider
9. PAN Slider
10. PHASE Button
11. ATT Slider
12. GROUP (GRP) Selector
13. LINK Switch
14. FX Ins Selector
15. DYNAMICS (DYN) Switch and Overview
16. EQ Switch and Overview
Drag the FADER slider to set the track channel’s CH EDIT FADER
parameter. The readout to the right of the slider shows the track
channel’s output level in dB.
Adjust the track channel’s stereo position by dragging the PAN
slider as desired—the current pan position is shown to the right of
the slider. When you move the slider, you’re adjusting the track
channel’s CH EDIT PAN parameter value.
Click “NRM” or INV” in the PHASE button to reverse the phase
polarity of the track channel’s signal.
Set the ATT slider to adjust the level of the signal coming from the
hard disk recorder into the track channel. The signal’s level is shown
to the right of the slider.
To assign the track channel to a fader group, click to the right of
“GRP” and select the desired fader group from the pop-up menu.
LINK combines the CH EDIT ChLink and F.LINK parameters. Click
to the right of “LINK” and select the desired type of linking from the
pop-up menu or turn off linking.
The numbers located right side of “FXINS” shows the status of effect
insertion. The number of effect currently inserted is highlighted. To turn
On/Off of the effect insertion or change insertion mode, Click number of
effect. You can select insertion mode or turn off on pop-up menu.
Turn on the track channel’s dynamics processor by clicking the DYN
switch. The current dynamics shape is shown graphically next to the
switch—when the switch is on, the shape becomes blue.
You set up a channel’s dynamics processing by drawing the desired shape with your
mouse in the CH VIEW screen as described on Page 63.
Turn on the track channel’s EQ by clicking the EQ switch. The
current EQ curve appears to the right of the switch—when the
switch is on, the curve turns blue.
You can set up a channel’s EQ by drawing the desired curve with your mouse in the CH
VIEW screen, as described on Page 63.
152
155
153
151
153
150, 154
215
151
152
VS2000v2Add.book 48 ページ ２００５年４月８日 金曜日 午後２時２４分