Roland VS-2000 - Page 64

6—VGA Main Display CH VIEW Screens
64 www.Roland.com Roland VS-2000 Owner’s Manual, Version Two Addendum
1. DYNAMICS On/Off Button
Turn the dynamics processor on or off by clicking this button—
when it’s blue, the processor is turned on.
2. RESET Button
Click RESET to return the dynamics processor to its factory default settings.
3. Interactive Dynamics Display
The interactive dynamics display lets you draw the shape of
your processing. Click and drag on any of the red triangles to
set the corresponding dynamics parameter.
4. Dynamics Type Selector
Click the desired button to select the type of dynamics processing you
want to use.
5. IN/OUT/GR Meters
These meters show, respectively, the signal coming into the processor, going out of it,
and the amount of dynamics processing being applied.
Type-Specific Parameters
The type-specific parameters change according to the type of dynamics processing you
select. These parameters are described in Owner’s Manual Chapter 11.
Owner’s Manual Page 160 explains how to understand what you
see in the graphic dynamics display.
Parameter: For compressor,
see Owner’s Manual Page:
For expander,
see Owner’s Manual Page:
KEY IN 159 159
RATIO 157 157
THRESHOLD 158 158
ATTACK 158 158
RELEASE 159 159
A.GAIN 158 not applicable
LEVEL 159 not applicable
VS2000v2Add.book 64 ページ ２００５年４月８日 金曜日 午後２時２４分