Roland VS-2000 - Page 75

7—Mixer Views
Roland VS-2000 Owner’s Manual, Version Two Addendum www.RolandUS.com 75
7. PAN Knob
8. TRACK STATUS Button
9. Channel Fader
10. LINK Switch
Set the stereo position of the channel in the main MASTER bus mix by
dragging the PAN knob up or down as desired.
Repeatedly click the TRACK STATUS button to set status of the
corresponding hard disk recorder track. This is the same thing as
pressing the track’s TRACK STATUS button on the VS-2000.
The position of the channel fader sets the level of signal coming out of
the channel.
LINK combines the CH EDIT ChLink and F.LINK parameters. Click
to the right of “LINK” and select the desired type of linking from the
pop-up menu, or turn off linking. The LINK switch occupies the
combined lower edge of both of the channels it controls.
155
176
152
150, 154
VS2000v2Add.book 75 ページ ２００５年４月８日 金曜日 午後２時２４分