Roland VS-2480 - Page 17

17
Preparations
Preparations
fig.battery1_69
4. The battery should now be visible, as shown in the following.
fig.battery2_69
5. If Effect Expansion Board (VS8F-2) installed on the EFFECT A section,
remove the VS8F-2 of the EFFECT A section.
6. Replace the old battery with a new one.
When turning the unit
upside-down, get a bunch
of newspapers or
magazines, and place them
under the four corners or at
b
oth ends to prevent
damage to the buttons and
controls. Also, you should
try to orient the unit so no
b
uttons or controls get
damaged.
CR2032
CR2032