18
Getting Ready
4
Use the Installation Tool supplied with the Wave Expansion
Board to turn the holders in the LOCK direction, so the board
will be fastened in place.
fig.Q-02c.e
5
Use the screws that you removed in step 2 to fasten the cover
back in place.
This completes installation of the Wave Expansion Board.
6
Connect the cables that you disconnected earlier.
7
Turn on the power, as described in “Turning On the Power” (p.
26).
8
Press [PATCH] to access the PATCH PLAY display.
fig.Q-03
Installation tool
LOCK
To Next Page
