RollSeal SC-325 User Manual

Part No 4801-5156 Rev 1-2017 RollSeal SC-325 & SC-650 Controllers Page 27
10.5 Installation of Prewired Switches
Prewired switches are available with Controllers 6607-8060, 6607-8061, 6607-8102, and 6607-8103. Cooler
Switches are prewired with a CPC quick connect. Prewire Switches have two switch assemblies: an Outside
Cooler Switch with a 6 foot harness and an Inside Cooler Switch with a 1.5 foot harness. Switch assemblies
are available in horizontal and vertical orientations. Shown below is vertical orientation.
1. Connect Outside switch to Controller with
CPC connection. Push and turn CPC
connector until it’s completely
locked in place.
2. Mount Outside Switch in desired location
on cooler wall.
Note: Cover removed for mounting.
3. Drill 1” hole through Cooler Wall to run
Inside Switch out to connect to Outside
Switch.
4. Route Inside Switch Harness through hole
and connect to bottom of Outside Switch
with CPC.
5. Mount Inside Switch in desired location.
Note: Cover removed for mounting.
6. Install Conduit Straps on conduit as required. Mount
a strap close to CPC connection to prevent
tampering. Insure conduit is run in a way to
prevent moisture from running into electrical
units.
7. Seal hole
10.6 Power Connection with Disconnect
1. Mount Disconnect in desired
location.
2. Connect harness from
Disconnect to Control with
CPC. Push and turn to lock
in place.
3. Remove Disconnect cover.
Switch must be in off
position to remove cover.
4. Connect conduit and
electrical supply to
Disconnect.
5. Connect 115V power supply
to Disconnect as shown in
Diagram.
6. Place cover back on
Disconnect.
7. Add conduit straps to conduit

RollSeal SC-325 Specifications

General

Brand	RollSeal
Model	SC-325
Category	Controller
Language	English