RollSeal SC-325 User Manual

Page 28 RollSeal SC-325 & SC-650 Controllers Part No 4801-5156 Rev 1-2017
10.7 Preparation for Operation
Note: If you detect any problems, STOP. Disconnect electrical power. Contact your
distributor for assistance.
1. Insert fuse in Control.
2. Apply 115VAC power to Control and turn Control toggle switch on.
3. See Section 6.4 Door Setup to set Open and Close Limits then proceed with the following steps.
Note: If door does not Open and Close to the proper position, see Section 6.4 for Open and
Close Limit setup procedure.
4. Press “Open” button on Outside Switch.
If the Door is set to automatically close, door will time out and automatically close if safety beams
are clear.
If the Door is set to manually close, press “Close” button on Outside Switch and door should close.
5. Press “Open” (and “Close” if required) a couple times to insure proper operation.
6. Press “Open” (and “Close” if required) with the Inside Switch a couple times to insure proper
operation.
7. Verify Safety Beams reverse door when blocked during closing.
8. Verify Leading Edge Switch is operational.
9. Verify that Warning Light and Egress Buzzer (if applicable) are functioning properly.
10. Ensure Safety Pull Hook and Hook Tether is mounted inside cooler and Manual Crank Handle for
motor is mounted outside.
The door is now ready for operation.
NOTE: See 4801-5154 RS500-600 Series Doors Installation Manual for more information on proper
Egress System installation.

RollSeal SC-325 Specifications

General

Brand	RollSeal
Model	SC-325
Category	Controller
Language	English