38
Step 1:
Remove the water tank
(previously remove the portafilter if
necessary).
Step 2:
Remove filter cartridge.
Step 6:
Place a vessel below the outlet of
the portafilter.
Step 3:
Fill decalcifier in the water tank.
Observe the “MAX” marking!
Step 4:
Insert the water tank.
Make sure the water tank is inserted
as far as it will go on the gasket.
Step 5:
Position the portafilter without filter
insert at the marking of the brew
head and lock it by turning it to the
right as far as it will go.
Step 7:
Choose the function
“espresso/hot water”.
Step 8:
Switch the appliance on.
The appliance heats up and the pilot
lamp blinks. When the lamp glows
permanently, the appliance is ready
for use.
Step 9:
Start descaling by tipping the switch
for 2 cups shortly. The appliance
stops automatically afterwards.
Repeat this process several times
until ca. 1/3 of the decalcifier has
flown through.
Step 11:
Repeat step 7 – 10 twice.
Check the collecting vessel regularly,
empty it if necessary.
Step 10:
Switch the appliance off.
Wait for 8 – 10 minutes so that the
decalcifier can soak.
Step 12:
Place a collecting vessel below the
outlet of the hot water/steam nozzle.
To Next Page
Loading...
